To configure the Order Replicator on your BlackArrow platform, you need to access the Replicator through the Trade menu:
In this section, you can configure the Master Account, where you will send the orders, and the Follower Accounts that will automatically copy the orders sent from the Master Account.
To begin your configuration, you must click on Create Replicator:
All accounts must be previously linked to the Platform in order for the configuration to be completed successfully.
In Master Account, choose the account from which you will manually send the orders. You can configure both your real accounts and simulation accounts.
Note: Automations and execution strategies cannot be used as the Master Account.
Below is an image showing the Master Account and the location of the follower accounts:
In Follower Accounts select which accounts will replicate the orders sent from the Master account. Once selected, the account will move to the column next to it.
It is possible to adjust the settings to allow the orders to be replicated identically or up to 10 times the amount performed on the Master Account.
Example: When sending an order for 2 contracts on the Master Account, with the multiplier set to 2x on the follower account, the replicated order will be for 4 contracts.
To complete the setup, you need to click "Finish." This way, the replicator will display the configured accounts.
It is necessary to change the status to "Replicating" on the follower account to replicate the trades.
To send orders, it is necessary to select the Replicator account in the trading tool.
The account will be highlighted in yellow, as shown in the example above.
All orders placed in this account will be automatically and simultaneously replicated in all accounts selected as followers, and at the multiplication factor configured by the user.
Note: Be sure to check that the margins and balance are available in all accounts so that the trades can be replicated without rejections.
Was this content helpful?
Please rate us down below.